ISSN:1000-8365 CN:61-1134/TG
Your Position :Home->Articles Online->2026 Vol.47 No.10

View Full-text
Study on the Residual Stress of Centrifugal Casting Ti60Alloy Intermediate Casing
Author of the article:TIAN Yuxuan1, CUI Yuefeng2, SHAO Zhulei2, ZHAN Yu1
Author's Workplace:1. College of Science, Northeastern University, Shenyang 110819, China; 2. AECC Shenyang Engine Research Institute,Shenyang 110015, China
Key Words:Ti60 alloy; intermediate casing; centrifugal casting; residual stress; ProCAST
Abstract:
To address the problem of residual stress control in the centrifugal casting process of an aeroengine Ti60 alloyintermediate casing, the optimization of process parameters was studied. A thermal-flow-force multifield coupling modelwas established by ProCAST, which was verified by X-ray diffraction experiments, and the effects of the centrifugationspeed, pouring temperature, pouring time and shell preheating temperature on the stress field were investigated by anorthogonal test system. The results show that the simulation and measurement error is only 9.0% , which confirms thereliability of the model. The maximum Mises stress decreases first but then increases with increasing pouring temperature,reaches a minimum value at 1 800 ℃, and decreases with increasing rotation speed and shell preheating temperature anddecreasing pouring time. The range analysis reveals that the maximum von Mises stress of the receiver is dominated by thepouring time and temperature and that the average von Mises stress is regulated by the centrifugation speed. Increasing therotational speed significantly enhances the fill uniformity and decreases the overall stress reference. The optimal process isdetermined to be group 23 (200 r/min, 1 850 ℃, 12 s, and 600 ℃), and the maximum and average Mises stresses are 589.9and 409.9 MPa, respectively, which realizes the coordinated regulation of local safety and overall stability.