Evolution of Surface Finish in Additively Manufactured AlSi10MgInternal Channels During Chemical Polishing
Author of the article:FU Zhongtao1, WANG Zhijun1, YANG Xudong2, LI Junjie1, WANG Jincheng1
Author's Workplace:1. State Key Laboratory of Solidification Processing, Northwestern Polytechnical University, Xi'an 710072, China; 2. XinchangTianQi Institute of Astronautics and Aeronautics, Shaoxing 312500, China
Key Words:additive manufacture; AlSi10Mg alloy; surface posttreatment; chemical polishing; corrosion behavior
Abstract:
Additively manufactured AlSi10Mg alloys are extensively utilized in integrated heat dissipation devices featuringcomplex internal flow channel geometries because of their comprehensive advantages, such as high thermal conductivityand favourable mechanical properties. However, the internal surface quality of as-built components is typically suboptimal,often necessitating postprocessing treatments to enhance their performance. Chemical posttreatment, unimpeded by theintricate geometry and dimensions of internal channels, is particularly suitable for the surface treatment of thesecomponents. Despite its potential, the alkaline chemical polishing process for AlSi10Mg alloy flow channels remainsunderdeveloped. To address this gap, we employed a self-developed room-temperature alkaline chemical polishing solutionto treat S-shaped flow channels, each with an inner diameter and wall thickness of 1 mm, under varying polishingdurations. The evolution of surface roughness on the overhang surface with respect to polishing time is systematicallyinvestigated through two-dimensional and three-dimensional morphological analyses to determine the optimal polishingtime.The results reveal that the surface roughness initially decreases sharply butsubsequently stabilizes withincreasingpolishing time. Specifically, the average Ra value decreases from 8.8 μm in the as-fabricated state to a minimumof 1.6 μm, corresponding to an approximate reduction of 82%. In the initial phase, the rapid removal of partially bonded powder, unmelted powder, and loose particles significantly enhances surface quality. During the intermediate phase, thedissolution and levelling of “slagging” defects further improve the surface quality, although at a slower rate. In the finalphase, detailed smoothing of the substrate occurs, with diminishing improvements in surface quality, eventually reaching afluctuating steady state. Furthermore, analysis of the cross-sectional melt pool morphology and corrosion behaviorcorroborates the observed surface morphology evolution.